Ticona Compel LFRT-長纖維增強塑料可擠出和壓塑

To extend your range of processing possibilities and to allow you to reap the benefits of very high modulus and extra high impact strength, Compel long fiber reinforced thermoplastic (LFRT) is an excellent material for extrusion compression molding. 

Compel LFRT products are made using a process that thoroughly wets out the glass fibers and delivers optimal reinforcement to the plastic matrix. Unlike conventional short-fiber reinforced materials, the longer fibers present in molded parts of Compel LFRT mechanically interact with each other to form an internal glass fiber “skeleton” that limits anisotropic shrinkage and greatly reduces warpage. Standard fiber length of Compel LFRT is 25 mm, somewhat longer than the 10 mm fiber used in Celstran® LFRT. The result is even higher impact strength.

Glass and carbon fibers are used to deliver the property balance required for a wide range of demanding uses. Polymer feedstock is typically polypropylene and nylon and all grades are heat-stabilized.

The combination of mechanical properties, creep and very high impact resistance, and low warpage imparted by LFRT products make them suitable candidates for metal replacement.  Typical applications include automobile front ends, instrument panel support brackets and control panels.

如果您想充分發揮加工工藝潛力，并在模量和抗沖上有更進一步的突破，Compel® LFRT（長纖維增強熱塑性塑料）將是您理想的選擇。它具有更長的增強纖維，并適用于擠出/壓塑成型工藝

Compel LFRT產品的制備工藝使長纖維在制備中被充分浸潤，從而為塑料基體提供了優化的增強效果。與常規的短纖增強材料不同，Compel LFRT部件中具有更長的增強纖維，而且它們相互纏繞，形成了一種纖維骨架，它能限制各向異性收縮，顯著降低翹曲。Compel LFRT的玻纖標準長度是25mm，比Celstran® LFRT中使用的10mm的玻纖更長。其結果是它具有更優越的抗沖強度

它通過使用玻纖和碳纖來提供滿足各種苛刻應用的綜合性能。典型的基體塑料為聚丙烯或尼龍。所有牌號都是熱穩定級。

綜合其優異的力學、抗沖擊、抗蠕變和低翹曲等性能，LFRT產品是金屬替代材料的理想候選者。典型應用包括汽車前端、儀表板骨架和控制面板。

為什么你需要Ticona工程塑料Compel LFRT,請看?泰科納工程塑料Compel LFRT的應用